The Home Water Report

You turn on the tap, the water runs strong for a few seconds, then the pump clicks off and back on again. Or you hear it kick on every few minutes overnight. If that sounds familiar, your well system is probably short-cycling, and the pressure tank is the first place to check.

What does the pressure tank do?

It stores a reserve of pressurized water so the pump does not have to run every time a faucet opens. Most tanks have a rubber bladder or diaphragm separating the water from a pocket of air. When the air holds the right pressure, the tank smooths out small draws. When the air is low, or water has crowded into the air side, the pump has to handle every little draw, and the switch keeps calling it on.

Why is the pump starting so often?

Frequent starts usually come from one of three things: low air pressure in the tank, a failed bladder that lets water fill the air side, or a leak that lets pressure drop between draws. Each one means the tank holds less usable water, so the pressure switch sees a drop and calls for a start. Short cycling is hard on the motor, the switch, and the wiring, so it is worth catching early.

How do you check it?

Start with the simple checks, and leave electrical work to a professional. Shut off power to the pump, open a faucet to drain the system until the flow stops, and then read the air valve on top of the tank with a standard tire gauge. Compare that reading with the pump's cut-in pressure, the point where it switches on. Many systems want the air charge a few pounds below that number, but the exact target depends on your equipment, so use the tank label or the pump manual rather than a rule of thumb.

If the gauge reads zero, the tank needs air. If air goes in and disappears within a day or two, you may have a leak or a failed bladder, and that calls for a service visit. If you are not comfortable working near the pump house, a licensed well contractor can run the same check quickly.

Where does automation fit in?

Many newer systems rely on controllers and switches rather than a homeowner listening for clicks. In a piece by Nan Johnson, Water Finance and Management's look at operational visibility notes that not long ago, automation was viewed primarily as a way to improve equipment operation, and that pumps "started and stopped automatically." That is useful when it works, but it can also hide a problem. A controller that quietly restarts the pump is still a pump that needs a look.

Ask any controller maker whether the unit logs starts or pressure readings, and ask what that log looks like. If your system has no log, keep a simple daily count of how often the pump runs. A week of counts gives you a baseline, and a jump in starts is your first warning.

Does a change in pump ownership matter?

Ownership changes are a separate question from how your tank works. On Nov. 9, Xylem Inc. announced it had completed its acquisition of Cornell Pump and Roper Pump, and the company said the move would advance its strategy to "sharpen its portfolio." For a homeowner, the practical question is whether your warranty, parts access, and service phone line stay the same. Read more in Water Finance and Management's report on the deal, then call your dealer and ask.

When should you get help?

If your readings look normal but the pump still cycles, ask a local dealer to check the whole system, not just the tank. Write down your start counts and tank readings before the visit so the technician has real numbers to work from. For example, Jones Air & Water offer free in-home water tests, which is one option to compare against other local providers.