The Home Water Report

You turn on the cold tap, and the glass fills with water that looks like skim milk. You set it on the counter, and after a minute it begins to clear from the bottom up. Many homeowners see this for the first time and assume something is wrong with the water. Usually the water is fine, and the cloudiness is air.

Why it clears from the bottom

Water under pressure can hold dissolved air, much like a soda holds carbon dioxide. When the pressure drops, as it does when water leaves the faucet and fills a glass, the air comes out as tiny bubbles. Those bubbles scatter light, which makes the water look milky. Because the bubbles rise, the water clears from the bottom of the glass toward the top. If the cloudiness is air, you will see that pattern every time.

This is most common after a service interruption, after someone drains a line for repairs, or on a private well where the pressure tank cycles often. It can also show up at a single hot tap when the water heater has just been refilled or is new. None of these situations means the water is contaminated, but they do mean the air is entering the system somewhere, and that is worth tracking if it keeps happening.

How to tell air from particles or minerals

Air is harmless and temporary. Other causes look different, and the difference matters.

Fine sediment or grit makes water cloudy in a way that does not clear within a minute or two. Particles may settle at the bottom of the glass as a visible layer, and you may feel grit when you rub the glass with a finger.

Hard water can leave a white, chalky film on fixtures. In hot water, dissolved calcium can also come out of solution as a faint haze. If the milkiness is strongest at hot taps and you also see scale on faucets or inside a kettle, hardness is the likely suspect. A hardness test will confirm it.

Rust-colored water is a different problem altogether. If the water looks yellow, orange, or brown and does not clear, check for iron before you blame the pipes. Color that stains laundry or fixtures points to a mineral question, not an air question.

A quick check you can do today

Try this sequence before you call anyone.

First, fill a clear glass from the cold tap and set it on the counter. Watch it for two minutes. Clearing from the bottom up points to air.

Second, repeat the test at a hot tap and at a tap farther from where the water enters the house. If only one fixture is cloudy, the cause is probably local, such as that fixture's aerator or a hot water tank.

Third, run the cold tap for several minutes, then test again. If the cloudiness persists after a good flush, sediment or a supply issue becomes more likely.

Fourth, check whether neighbors have the same problem. A utility notice or work on your street changes the answer completely, and a single call to the utility can settle the question.

Fifth, look at your filtration. A clogged sediment filter can release particles, and a freshly installed cartridge can shed fine material for a day or two. If the cloudiness started right after a filter change, that is a strong clue.

When to call for help

Call your utility if the cloudiness covers many homes, comes with a change in taste or smell, or follows a known main break or repair. If you are on a private well, a pump or pressure tank technician can check whether air is getting into the system, which is one of the most common causes of persistent milky water on wells.

Keep a short note of when you noticed the problem, which taps were affected, and whether the water cleared. That record makes every conversation faster, whether it is with the utility, a plumber, or a water treatment dealer.

Stories about large water projects, such as the Circle of Blue report headlined "Nearly a Billion Dollars to Clean Up Lake Champlain" in its report on lake cleanup efforts, focus on lakes and watersheds. They do not tell you what is in your glass this morning. Your answer comes from that glass, a few simple checks, and, when needed, a test from a certified lab.